Deleted
Registered: Dec 4, 2024 12:44:14 GMT -7
Posts: 0
|
Post by Deleted on Jan 31, 2016 11:59:44 GMT -7
Hi Gang, does any body have an easy way to drill the plug wire holes in a dist. to make them in a circle with the proper spacing ??
I'm working on a 1/16th scale dist. want to use yellow plug leads instead of the black tubing that comes in the kit. I've tried a couple of different ways but they haven't worked out so good. smiley-confused005 |
|
|
|
Post by Gothicz House Of Kustomz on Feb 5, 2016 0:30:29 GMT -7
I use my old diabetic needles, ya can use a plastic tube that fits the nibs, or make one out of plastic rod, just use the pin vice micro drill bit, then pop onto the nib, and drill....
|
|
Deleted
Registered: Dec 4, 2024 12:44:14 GMT -7
Posts: 0
|
Post by Deleted on Feb 5, 2016 8:27:48 GMT -7
A short piece of aluminum tubing can help guide the drill bit. Although, even at that scale,I think once you have the wires in, the spacing would not be noticed.
Worst case scenario, I'm sure you can find an aftermarket one.
|
|
Deleted
Registered: Dec 4, 2024 12:44:14 GMT -7
Posts: 0
|
Post by Deleted on Feb 5, 2016 22:29:16 GMT -7
A short piece of aluminum tubing can help guide the drill bit. Although, even at that scale,I think once you have the wires in, the spacing would not be noticed. Worst case scenario, I'm sure you can find an aftermarket one. Pro- Tech is the only 1/16th dist. I have found but it is so large for a 1/18 or 1/16th scale, I would say it was for a 1/12th scale and no detail just the plug wire holes started.
Thanks for the help guys, I think I got it figured out smiley-greet016
|
|
