|
Post by Gothicz House Of Kustomz on Jul 12, 2014 6:56:43 GMT -7
|
|
|
Post by stevet on Sept 6, 2014 5:15:08 GMT -7
very cool what do you use to fasten down the dremel tool to make it stationary because of torque, clamps, vice?
|
|
Deleted
Registered: May 18, 2024 7:25:12 GMT -7
Posts: 0
|
Post by Deleted on Sept 6, 2014 8:54:20 GMT -7
another way of doing this same thing is if you have a 2 speed drill, to hold the "sprue" with the chuck as the drill is clamped to a bench and a rifler file used for the shaping there of the sprue to get a coil, even shocks as used when the stock ones won't work due to custom fitting of parts to that specific model that its actually not a factory part too, you can even turn your own distributors this way as well as oil filters, and even "straight" axles for making a Gasser...
Just remember the smaller the diameter, the faster the drill needs to spin, and then to use the correct sized pointed file as well and work SLOWLY, much to fast (added pressure) will hawg out WAY to much "stock" on the sprue much to fast to even notice, specially at high RPMs of the drill.....
Another way is if you have a lathe, they do it best, BUT a drill press will work much the same way and you don't have to "clamp" it to the bench it ought to hold itself steady due to having a "foot" whether a bench model drill press, OR a floor model.....
|
|
|
Post by Gothicz House Of Kustomz on Sept 6, 2014 13:56:51 GMT -7
very cool what do you use to fasten down the dremel tool to make it stationary because of torque, clamps, vice? just clamp it right into the chuck
|
|
|
Post by stevet on Sept 6, 2014 16:38:28 GMT -7
No, I mean the dremel tool itself not the chuck?
|
|
|
Post by Gothicz House Of Kustomz on Sept 6, 2014 20:31:26 GMT -7
myself I just lay it on the table, hold it with my hand, for safty, should use a vice
|
|
|
Post by stevet on Sept 7, 2014 11:48:59 GMT -7
thanks, that's what I thought.... smileyCA9464IN_zpsd9ee499f
|
|
|
Post by sharp on Sept 26, 2014 17:46:34 GMT -7
You could make a dremel holder with a piece of wood and a hose clamp.
|
|
|
Post by stevet on Sept 27, 2014 11:12:57 GMT -7
Yep, I'll figure out something.. thinking-hard-smiley-emoticon
|
|